Asus USB-N11 - Manual (Page 15)

ASUS WLAN Adapter 1
Chapter - Software Reference
Chapter
So
ftw
ar
e
Re
fe
re
nc
e
Scanning... : The station is trying to authenticate and associate with an access point or Ad Hoc
node.
Disconnected: The WLAN Adapter is installed to the system, but not yet connected to a wireless
device.
SSID: Displays the Service Set Identifier (SSID) of the device that the adapter
is either associated or intending to join.
MAC address: Shows the hardware address of the WLAN Adapter. MAC
address is a unique identifier for networking devices (typically written as twelve
hexadecimal digits from 0 through 9 and A through F separated by colons, i.e.
00:E0:18:F0:05:C0).
Current Channel: Displays the radio channel to which the adapter
is currently tuned. This number changes as the radio scans the available
channels.
Current Data Rate: Displays the current data rate in megabits per second
(Mbps).
Radio State: Shows the wireless radio status: ON or OFF.
Radio On - When the wireless radio is turned ON, the icon on the right
appears in the upper left of the Status page.
Radio Off - When the wireless radio is turned OFF, the icon on the right
appears in the upper left of the Status page.
Buttons
Rescan – Make the WLAN Adapter rescan all available devices. If the current
link quality or signal strength is poor, rescanning can be used to push the radio
off a weak access point and search for a better link with another access point.
This function usually takes several seconds.
Change SSID – Click this button to set the SSID to that of the AP you want to
connect.
Search & Connect – Click this button to connect to an available wireless AP.
NOTE: For 802.11n performance, select 40MHz bandwidth in wireless
router. Channel option depends on the bandwidth that you select.