Asus TUSI-M - Manual (Page 17)

ASUS TUSI-M User’s Manual 17
3. HARDWARE SETUP
Motherboard Settings
3. H/W SETUP
1) JumperFree ™ Mode (JEN)
This jumper enableS or disableS the JumperFree ™ mode. The default enables
JumperFree ™ mode, which permits processor frequency settings through the BIOS
setup (see 4.4 Advanced Menu). Disabling JumperFree ™ mode permits manual
frequency settings using JP0-JP3; (see the following page).
IMPORTANT: In JumperFree ™ mode, all jumpers must be set to [1-2].
2) USB Device Wake Up (USBPWR0, USBPWR1)
These jumpers allow you to enable or disable the USB device power up function
for USB devices connected to your system.This feature requires an ATX power
supply that can supply at least 2A on the +5VSB lead. The default is set to
Disable because not all computers have the appropriate ATX power supply. Your
computer will not power ON if you set these to Enable and do not have the
appropriate ATX power supply.
NOTES:
1. These two jumpers must be set in unison; that is, either both must be set to
Disable or both to Enable.
2. These settings must also be set in conjunction with Wake On USB Device in
4.5.1 Power Up Control.
TUSI-M ®
01
TUSI-M USB Device Wake Up
Enable Disable
(Default)
1
2 2
3
Enable Disable
(Default)
1 2 2 3
USBPWR0
USBPWR1
TUSI-M
01
TUSI-M JumperFree™ Mode Setting
JEN
JumperFree Mode
1 2
Jumper Mode
1 2
JP3 JP1 JP2 JP0
3
2
1