Asus A7N8X - Manual (Page 51)

ASUS A7N8X Motherboard 2-21
Video Off Method [DPMS Support]
This field defines “video off” features. The DPMS support option (Display Power
Management System) permits the BIOS to control the video display card if it supports
the DPMS feature. Blank Screen option blanks the screen; use blank screen for
monitors without power management or “green” features. [V/H SYNC+Blank] blanks
the screen and turns off vertical and horizontal scanning. Configuration options: [Blank
Screen] [V/H SYNC+Blank] [DPMS Support]
HDD Down In Suspend [Disabled]
This field sets whether or not the HDD is automatically shut down in suspend mode.
The default disables power to the HDD in suspend mode. Configuration options:
[Enabled] [Disabled]
PWR button < 4 Secs [Suspend]
This field sets the delay after which the system powers off after depressing the external
case-mounted power button. The default setting powers off the system instantly.
Configuration options: [Soft-Off] [Suspend]
Power Up on PCI Device [Enabled]
This field enables Wake-On-LAN from soft-off mode. The default disables this option.
Configuration options: [Enabled] [Disabled]
Wake-Power Up On Ext. Modem [Disabled]
This field allows either settings of [Enabled] or [Disabled] for powering up the computer
when the external modem receives a call while teh computer is in Soft-off mode.
Configuration options: [Enabled] [Disabled]
Automatic Power Up [Disabled]
This field sets to enable or disable the automatic power up.When [Enabled] the Time
(hh:mm:ss) of Alarm field is enabled for input.
Configuration options: [Enabled] [Disabled]
Time (hh:mm:ss) of Alarm 0:00:00
This field sets the time for automatic power up. Enter the hour, minute and second
based on the 24 hour clock. The Automatic Power Up field must be enabled to use
this feature.
AC Power Loss Re-Start [Disabled]
This allows you to set whether or not to reboot the system after power interruptions.
[Disabled] leaves your system off while [Enabled] reboots the system. [Previous State]
sets the system back to the state it was before the power interruption.
Configuration options: [Disabled] [Enabled] [Previous State]