Asus A7N8X - Manual (Page 50)

2-20 Chapter 2: BIOS Setup
2.4.4 Power Management Setup
UART use as [COM Port]
This field selects the device assignment for UART2 mode. The default is [COM
Port]. Select [IR] to activate the next field, “UR2 Duplex Mode”.
Configuration options: [IR] [COM Port]
Onboard Parallel Port [378/IRQ7]
This field sets the address of the onboard parallel port connector to 378/IRQ7 by
default. Disabling the port makes the parallel port unavailable. Configuration options:
[Disabled] [378/IRQ7] [278/IRQ5] [3BC/IRQ7]
Parallel Port Mode [SPP]
This field sets the operation mode of the parallel port. The default, SPP, enables
normal-speed operation but in one direction only; EPP enables bidirectional parallel
port operation; ECP enables the parallel port to operate in bidirectional DMA mode;
ECP+EPP enables normal speed operation in a both ECP and EPP modes. Select
[ECP] to access the next field, “ECP Mode Use DMA”. Configuration options: [SPP]
[EPP] [ECP] [ECP +EPP]
ECP DMA Select [3]
This field sets the parallel port DMA channel for the selected ECP mode. The default
setting is 3. This selection is available only if you select [ECP] or [ECP+EPP] in
Parallel Port Mode above. Configuration options: [1] [3]
Onboard Game Port [201]
This field sets the address of the game port t0 201 by default. Disabling the game
port makes the port unavailable. Configuration options: [Disabled] [201] [209]
Onboard MIDI I/O [330]
This field sets the address of the MIDI I/O port to 330 by default.
Configuration options: [Disabled] [330] [300]
ACPI Suspend to RAM [Disabled]
This field enables or disables suspension to RAM. Configuration options: [Enabled]
[Disabled]