Asus P5KPL-C - Manual (Page 74)

2-24 Chapter 2: BIOS setup
North Bridge Configuration
Memory Remap Feature [Disabled]
Allows you to enable or disable the remapping of overlapped PCI memory above
the total physical memory. We recommend that you set this item to Enabled when
you install 4GB memory. Configuration options: [Enabled] [Disabled]
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configurating DRAM Timing by SPD.
Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device.
Configuration options: [PCI/PEG] [PEG/PCI]
[PEG/PCI] - Sets PCI Express x 16 graphics card as the primary display controller.
[PCI/PEG] - Sets the PCI graphics card as the primary display controller.
North Bridge chipset Configuration
Memory Remap Feature [Disabled]
Configure DRAM Timing by SPD [Enabled]
Initiate Graphic Adapter [PEG/PCI]
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory
South Bridge Configuration
Options
South Bridge chipset Configuration
Audio Controller [Azalia]
Front Panel Support Type [HD Audio]
Audio Controller [Azalia]
Allows you to set the audio controller. Configuration options: [Azalia] [Disabled]
Front Panel Support Type [HD Audio]
Allows you to select the front panel support type. If High Definition Audio
Front Panel used, please set HD Audio mode. Configuration options: [AC97]
[HD Audio]
Azalia
All Disabled