Sb710 controller, M4a78lt plus speaker out connector, Speaker – Asus M4A78LT PLUS User Manual
Page 29

4.
AMD
®
SB710 Serial ATA 3.0 Gb/s connectors (7-pin SATA6G_1~4)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard disk
drives. If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, or
RAID 10 configuration through the onboard AMD
®
SB710 controller.
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.3.4 SATA Configuration for details.
• You must install Windows
®
XP Service Pack 3 or later version before using Serial
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
®
XP SP3 or later version.
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.3.4 SATA Configuration for details.
SATA3G_3
SATA3G_1
SATA3G_4
SATA3G_2
GN
D
RSATA_RXN1
RSATA_RXP1
GN
D
RSATA_TXN1
RSATA_TXP1
GN
D
GN
D
RSATA_TXP3
RSATA_TXN3
GN
D
RSATA_RXP3
RSATA_RXN3
GN
D
GN
D
RSATA_RXN2
RSATA_RXP2
GN
D
RSATA_TXN2
RSATA_TXP2
GN
D
GN
D
RSATA_TXP4
RSATA_TXN4
GN
D
RSATA_RXP4
RSATA_RXN4
GN
D
M4A78LT PLUS
M4A78LT PLUS SATA connectors
5.
Speaker connector (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The speaker
allows you to hear system beeps and warnings.
M4A78LT PLUS
M4A78LT PLUS
Speaker out connector
+5
V
GN
D
GN
D
Speaker Out
SPEAKER
PIN 1
ASUS M4A78LT PLUS
1-19