Asus CUC2000 - Manual (Page 20)

20 ASUS CUC2000 User’s Manual
3. HARDWARE SETUP
Motherboard Settings
3. H/W SETUP
4) Automatic Timeout Reboot Setting (NO_REBOOT)
The motherboard is set so that when the BIOS detects a hang (timeout) during
bootup, the motherboard will automatically reboot. If rebooting is repeating in-
effectively, set this jumper to No Reboot to disable auto-reboot. However, if
Safe Mode Setting (SAFE_MODE) is set to Safe Mode, setting Automatic
Timeout Reboot Setting (NO_REBOOT) to No Reboot will bring the system
to Safe Mode so you may be able to correct any problems.
Setting NO_REBOOT
Normal [1-2] (default)
No Reboot [2-3]
CUC2000
®
CUC2000 Reboot Setting
Normal
(Default)
No Reboot
NO_REBOOT
1 2 2 3
5) Onboard Audio CODEC Setting (AUD_EN1 / AUD_EN2)
(available on audio model only)
The onboard audio CODEC may be enabled or disabled using all of these jump-
ers. Disable the onboard audio CODEC if you are using an ISA or PCI audio
card on any of the expansion slots or a primary AMR on the AMR slot (see AMR
Slot later in this section). If using an ISA or PCI audio expansion card, On-
board AC97 Audio Controller in 4.4.2 I/O Device Configuration must also be
disabled.
CUC2000 Audio Codec Setting
CUC2000
®
Disable Enable
(Default)
1 2 2 3
SPK
ADN#
AUD_EN1
AUD_EN2 SPK
ADN#
AUD_EN1
AUD_EN2