Asus P3C-D - Manual (Page 43)

ASUS P3C-D User’s Manual 43
3. HARDWARE SETUP
Connectors
3. H/W SETUP
12) Wake-On-LAN Connector (3-pin WOL_CON)
The WOL_CON connector powers up the system when a wake-up packet or
signal is received from the network through the ASUS PCI-L101 LAN card.
IMPORTANT: This feature requires that Wake-On-LAN is set to Enabled (see
4.5.1 Power Up Control) and that your system has an ATX power supply with at least
720mA +5V standby power.
P3C-D
P3C-D Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
+5 Volt Standby PME
Ground
WOL_CON
13) Wake-On-Ring Connector (2-pin WOR)
This connector connects to an internal modem card with a Wake-On-Ring out-
put. The connector powers up the system when a ringup packet or signal is re-
ceived through the internal modem card. NOTE: For external modems, Wake-
On-Ring is detected through the COM port.
IMPORTANT: This feature requires that PWR Up On Modem Act is set to
Enabled (see 4.5.1 Power Up Control).
P3C-D Wake-On-Ring Connector
WOR
Ring# Ground
2 1
P3C-D