Asus P5P43T - Manual (Page 59)

ASUS P5P43T 2-21
AddOn ROM Display Mode [Force BIOS]
Sets the display mode for option ROM. Configuration options: [Force BIOS]
[Keep Current]
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
Wait For ‘F1’ If Error [Enabled]
When set to Enabled, the system waits for the F1 key to be pressed when error occurs.
Configuration options: [Disabled] [Enabled]
Hit ‘DEL’ Message Display [Enabled]
When set to [Enabled], the system displays the message Press DEL to run Setup during
POST. Configuration options: [Disabled] [Enabled]
2.7.4 Security
The Security menu items allow you to change the system security settings. Select an item
then press to display the configuration options.
Set this item to [Enabled] to use the ASUS MyLogo2 ™ feature.
2.7.2 Hard Disk Drives
1st ~ xxth Drive
These items specify the boot device priority sequence from the available hard drives. The
number of drive items that appears on the screen depends on the number of hard drives
installed in the system. Configuration options: [Hard Drive] [Disabled]
2.7.3 Boot Settings Configuration
Quick Boot [Enabled]
Enabling this item allows the BIOS to skip some power on self tests (POST) while booting to
decrease the time needed to boot the system. When set to [Disabled], BIOS performs all the
POST items. Configuration options: [Disabled] [Enabled]
Full Screen Logo [Enabled]
This allows you to enable or disable the full screen logo display feature. Configuration
options: [Disabled] [Enabled]