Asus M4N78-AM - Manual (Page 40)

2-16 ASUS M4N78-AM
2.7 Tools menu
2.7.1 ASUS EZ Flash 2
Allows you to run ASUS EZ Flash 2. After you press , a confirmation message
appears. Use the left/right arrow key to select between [Yes] or [No], then press to
confirm your choice.
Change User Password
Select this item to set or change the user password. The User Password item on top of the
screen shows the default Not Installed. After you set a password, this item shows Installed.
To set a User Password:
1.
Select the Change User Password item.
2. From the password box, key in a password composed of up to six letters and/or
numbers, then press .
3. Confirm the password when prompted.
The message Password Installed appears after you set your password successfully.
To change the user password, follow the same steps in setting a user password.
Clear User Password
Select this item to clear the user password.
Password Check [Setup]
When set to [Setup], BIOS checks for user password when accessing the Setup utility. When
set to [Always], BIOS checks for user password both when accessing Setup and booting the
system. Configuration options: [Setup] [Always]
ASUS EZ Flash 2
AI NET2
Press ENTER to run
the utility to select
and update BIOS.
BIOS SETUP UTILITY
Main Advanced Power Boot Tools Exit
2.8 Exit menu
The Exit menu items allow you to load the optimal or failsafe default values for the BIOS
items, and save or discard your changes to the BIOS items.
Exit Options
Exit & Save Changes
Exit & Discard Changes
Discard Changes
Load Setup Defaults
Exit system setup
after saving the
changes.
F10 key can be
used for this
operation.
2.7.2 AI NET 2
Check Broadcom Phy LAN cable [Disabled]
Enables or disables checking of the Broadcom LAN cable during the Power-On Self-Test
(POST). Configuration options: [Disabled] [Enabled]