Asus K8V SE Deluxe - Manual (Page 102)

4-36 Chapter 4: BIOS Setup
After you have set a supervisor password, the other items appear to allow
you to change other security settings.
User Access Level (Full Access]
Allows you to select the access restriction to the Setup items.
Configuration options: [No Access] [View Only] [Limited] [Full Access]
No Access prevents user access to the Setup utility.
View Only allows access but does not allow change to any field.
Limited allows change only to selected fields, such as Date and Time.
Full Access allows viewing and changing all the fields in the Setup
utility.
Change User Password
Select this item to set or change the user password. The User Password
item on top of the screen shows the default Not Installed. After you have
set a password, this item shows Installed.
To set a User Password:
1. Select the Change User Password item and press .
2. On the password box that appears, type a password combination of at
least six (6) letters and/or numbers, then press .
If you forget your BIOS password, you can clear clear it by erasing the
CMOS Real Time Clock (RTC) RAM. See section “2.6 Jumpers” for
information on how to erase the RTC RAM.
To clear the supervisor password, select the Change Supervisor Password
then press . The message “Password Uninstalled” appears.
Security Settings to change
password.
Supervisor Password : Installed again to
User Password : Not Installed disabled password.
Change Supervisor Password
User Access Level
[Full Access]
Change User Password
Clear User Password
Password Check
[Setup]
Boot Sector Virus Protection [Disabled]