Asus A8N-E - Manual (Page 85)

A S U S A 8 N - E A S U S A 8 N - E A S U S A 8 N - E A S U S A 8 N - E A S U S A 8 N - E 2 - 3 9 2 - 3 9 2 - 3 9 2 - 3 9 2 - 3 9
Typematic Rate (Chars/Sec) [6] Typematic Rate (Chars/Sec) [6] Typematic Rate (Chars/Sec) [6] Typematic Rate (Chars/Sec) [6] Typematic Rate (Chars/Sec) [6]
Allows you to select the rate at which a character repeats when you hold a
key. Configuration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250] Typematic Delay (Msec) [250] Typematic Delay (Msec) [250] Typematic Delay (Msec) [250] Typematic Delay (Msec) [250]
Allows you to set the delay before keystrokes begin to repeat.
Configuration options: [250] [500] [750] [1000]
OS Select for DRAM > 64MB [Non-OS2] OS Select for DRAM > 64MB [Non-OS2] OS Select for DRAM > 64MB [Non-OS2] OS Select for DRAM > 64MB [Non-OS2] OS Select for DRAM > 64MB [Non-OS2]
Set this item to OS2 only when you are running on an OS/2 operating
system with an installed RAM of greater than 64 KB.
Configuration options: [Non-OS2] [OS2]
Full Screen LOGO [Enabled] Full Screen LOGO [Enabled] Full Screen LOGO [Enabled] Full Screen LOGO [Enabled] Full Screen LOGO [Enabled]
Allows you to enable or disable the full screen logo display feature.
Configuration options: [Disabled] [Enabled]
• Make sure that the above item is set to [Enabled] if you want to use
the ASUS MyLogo2™ feature.
• See section “3.3.1 ASUS MyLogo2™” for details.
Halt On [All Errors] Halt On [All Errors] Halt On [All Errors] Halt On [All Errors] Halt On [All Errors]
Allows you to error report type.
Configuration options: [All Errors] [No Errors] [All, But Keyboard]
[All, But Diskette] [All, But Disk/Key]
2.6.6 2.6.6 2.6.6 2.6.6 2.6.6 Security Security Security Security Security
Select Menu
Item Specific Help
Boot Settings Configuration
Supervisor Password Clear
User Password Clear
Password Check [Setup]
Phoenix-Award BIOS CMOS Setup Utility
Boot
Supervisor Password Supervisor Password Supervisor Password Supervisor Password Supervisor Password
User Password
User Password User Password User Password User Password
These fields allow you to set passwords:
To set a password:
1. Select an item then press .
2. Type in a password using a combination of a maximum of eight (8)
alpha-numeric characters, then press .