Asus A8N-E User Manual

Page 44

1 - 3 0

C h a p t e r 1 : P r o d u c t i n t r o d u c t i o n

1 2 .

1 2 . Front panel audio connector (10-1 pin FP_AUDIO)

F r o n t p a n e l a u d i o c o n n e c t o r ( 1 0 - 1 p i n F P _ A U D I O )

F r o n t p a n e l a u d i o c o n n e c t o r ( 1 0 - 1 p i n F P _ A U D I O )
This connector is for a chassis-mounted front panel audio I/O module
that supports legacy AC ‘97 audio standard. Connect one end of the
front panel audio I/O module cable to this connector.

1 1 .

1 1 . Chassis intrusion connector (4-1 pin CHASSIS)

C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S )

C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S )
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature. See related BIOS item in
page 2-42.

A8N-E

A8N-E Chassis intrusion connector

CHASSIS

+5VSB_MB

Chassis Signal

GND

(Default)

A8N-E

A8N-E Front panel audio connector

FP_AUDIO

BLINE_OUT_L

MIC2

Line out_R

Line out_L

BLINE_OUT_R

MICPWR

+5VA

AGND