beautypg.com

Asus AP120-E1 User Manual

Page 77

background image

ASUS P4P800S-E Deluxe motherboard user guide

4-13

Enhanced Mode Support On [S-ATA]

The default setting S-ATA allows you to use native OS on Serial ATA
and Parallel ATA ports. We recommend that you do not change the
default setting for better OS compatibility. In this setting, you may use
legacy OS on the Parallel ATA ports only if you did not install any
Serial ATA device.

The P-ATA+S-ATA and P-ATA options are for advanced users only. If
you set to any of these options and encounter problems, revert to the
default setting S-ATA. Configuration options: [P-ATA+S-ATA] [S-ATA]
[P-ATA]

IDE Port Settings [Primary P-ATA+S-ATA]

Allows selection of the IDE ports to activate if you are using a legacy
operating system. Set to [Primary P-ATA+S-ATA] if you wish to use the
primary Parallel ATA and Serial ATA ports, or set to [Secondary
P-ATA+SATA] to enable the secondary P-ATA port instead. Setting to
[P-ATA Ports Only] disables the two Serial ATA ports supported by
ICH5. Configuration options: [Primary P-ATA+S-ATA] [Secondary
P-ATA+S-ATA] [P-ATA Ports Only]

Refer to the section “Parallel ATA and Serial ATA device configurations” on page 2-
26 for the appropriate settings of the IDE Configuration items under different
operating systems.

The Enhanced Mode Support On appears only when the item Onboard IDE
Operate Mode
is set to Enhanced Mode.

The IDE Port Settings appears only when the item Onboard IDE Operate Mode
is set to Compatible Mode.

Configure S-ATA as RAID [No]

This field configures the S-ATA to function as an IDE controller or
RAID. Configuration options: [Yes] [No]

Serial ATA BOOTROM [Disabled]

This field enables or disables the Serial ATA BOOTROM.
Configuration options: [Disabled] [Enabled]

The Serial ATA Boot ROM item appears only when the item Configure S-ATA as
RAID
is set to [Yes].

This manual is related to the following products: