Asus GigaX2124X/C - Manual (Page 73)

GigaX Series L2 Managed Switch User Guide
73
[Flow Control] [Enable/Disable]
Displays the IEEE802.3x flow control setting of a port. Note that this flow
control is operating only in full duplex mode.
CLI command : l2 port flow
[Reload]
Restores the previous port settings from the configuration file.
CLI command : sys l2 port retrieve
5.3.3 Bridge Commands
[Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]
Allows user to specify whether the switch participates the Spanning Tree
Protocol (STP/ RSTP).
CLI command : l2 stp start
CLI command : l2 stp stop
[Hello Time]
[Forward Delay]
[Max Age]
[Bridge Priority]
Displays the current STP/RSTP bridge parameters setting.
CLI command : l2 stp bridge set
Hello Time (1..10 seconds):[old Hello Time]
Max Age (6..40 seconds):[ old Max Age]
Forward Delay (4..30 seconds):[ old Forward Delay] Delay>
Bridge Priority (0..65535):[ old Bridge Priority]