Asus WL-330gE - Manual (Page 67)

5-3 ASUS WL-330gE Portable Wireless Access Point
5.3 Replacing the cable connections of other
devices
You can also use the WL-330gE to replace your Xbox, PlayStation ® 2, orset-top
box network cable connection.
To do this:
1. Switch the WL-330gE to Ethernet adapter mode using the mode switch.
(Default SSID: ANY)
2. Place the WL-330gE nearest the AP you wish to connect, then turn on the
device.
3. Connect one end of the supplied RJ-45 cable to the Ethernet port of the device
and the other end to the Xbox, PlayStation ® 2, or set-top box Ethernet port.
4. Set the IP address of the Xbox, PlayStation ® 2, or set-top box toestablish
connection to the local network. Verify your connection.
Make sure the WL-330gE MAC cloning feature is enabled when using the
device in this setup. Use the Wireless Setting Utility to enable MAC cloning. See
page 3-24 for details on MAC cloning.
5.4 Sharing Internet connection with other
computers
Refer to the typical network configuration below and a table on the next page for
information on Internet connection sharing with other computers in your office or
home network.
Use the mode switch to set the WL-330gE to AP mode before sharing an
Internet connection with other computers in your network.
Wireless computer Internet
˝
ADSL/Cable modem WL-330gE