Asus Rampage IV Extreme - Manual (Page 57)

ROG RAMPAGE IV EXTREME 2-33
Chapter 2
3. ASMedia ® Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [red])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• The SATA6G_E1/E2 (red) connectors are for data drives only. ATAPI device is not
supported.
• You must install Windows ® XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• When using NCQ, set the Asmedia Storage Controller item in the BIOS to [Enabled].
Refer to section 3.5.5 Onboard Devices Configuration for details.
4. Subzero Sense connector
The Subzero Sense connector allows you to connect the K probe cable (purchased
seperately) to measure the motherboard temperature via BIOS, OC Key or
TurboV EVO without purchasing expensive multimeters.
Subzero Sense detects the connector’s ambient temperature when it’s plugged.