Asus M2N-LR/SATA - Manual (Page 68)

ASUS M2N-LR Series -
PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode.
Configuration options: [Auto] [SWDMA0] [SWDMA1] [SWDMA2] [MWDMA0]
[MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4] [UDMA5]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration
options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press if you wish to
configure the item.
OnBoard PCI IDE Controller [Enabled]
Enables or disables primary IDE controllers.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Device 0/1/2]
Enables or disables the SATA0/1/2 IDE Interfaces.
Configuration options: [Disabled] [Device 0] [Device 0/1] [Device 0/1/2]
IDE Configuration
OnBoard PCI IDE Controller [Enabled]
Serial-ATA Devices [Device 0/1/2]
nVidia RAID Setup
Hard Disk Write Protect [Disabled]
IDE Dectect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host]
DISABLED: disables
the intergrated IDE
Controller.
PRIMARY: enables
only the Primary IDE
Controller.
SECODARY: enables
only the Secondary
IDE Controller.
BOTH: enables both
IDE Controllers.