Asus WL-320gE - Manual (Page 47)

.
T
ro
ub
le
sh
oo
tin
g
ASUS 802.11g Access Point 7
Chapter -Troubleshooting
Problem
The ASUS AP Device Discovery still
cannot find or connect to the ASUS
AP after verifying the IP address and
LAN cable, changes cannot be made,
or password is lost.
Solution
In case the ASUS AP is inaccessible,
you can restore the ASUS AP’s factory default settings. Use a straightened
paper clip to press the button located in the hole on the back of the ASUS
AP and keep it depressed over 5 seconds. The power LED will darken and
then light up when reset is successful.
Reset to Defaults
The following are factory default values. These values will be present when you
first receive your the ASUS AP , if you push the reset button on the back of the
ASUS AP over 5 seconds, or if you restore factory settings through the ASUS
AP software.
Name Default Value
Wireless - Interface
SSID default
Channel 6
Encryption (WEP) None
Broadcast SSID No
Wireless - Bridge
AP Mode Access Point Only
Wireless - Access Control
MAC Access Mode Disabled
IP Config - LAN
IP Address 192.168.1.1
Get IP Address Automatically Yes
Subnet Mask 255.255.255.0
Gateway (blank)
System Setup - Password
Operation Mode Access Point
User Name admin
Password admin