Asus WL-320gE - Manual (Page 35)

3. Software
ASUS 802.11g Access Point 3
Chapter 3 - Software Configuration
Access Point
Note: Click the “Finish” button to save your new settings and restart
the ASUS 802.11g AP or click “Save” and restart later.
Adding a MAC Address
To add a MAC address, enter the 12 hexadecimal characters into the white box
next to “MAC Address:” and click the Add button. The MAC address will
be placed in the control list below. Only a total of 31 MAC addresses can
be entered into this page so determine which will be the lesser; those you
wish to accept or those you wish to reject and click the appropriate “MAC
Access Mode”.
3.7. RADIUS Setting
Note: Click the “Finish” button to save your new settings and restart
the ASUS 802.11g AP or click “Save” and restart later.
This section allows you to set up additional parameters for connection with
RADIUS Server. It is required while you select “Authentication Method”
as “WPA” or “Radius with 802.1x” in “Wireless – Interface”.
Server IP Address - This field specifies the IP address of the RADIUS
server to use for 802.1X wireless authentication and dynamic WEP key
derivation.
Server Port - This field specifies the UDP port number used by the RADIUS
server.
Connection Secret - This field specifies the password used to initialize a
RADIUS connection.