Connecting_to_the_network – Net Optics 10_100_1000 Copper Port Aggregator User Manual
Page 11
10/100/1000 Copper Port Aggregator Tap
7
Figure_5. Connecting to the Network
Note:_________________________________________________________________
The network links connected to the 10/100/1000 Copper Port Aggregator must
run with autonegotiation. Be sure to configure the ports on the switches and
rouuters for autonegotiation if you are cabling them to this device.
______________________________________________________________________ _
Connecting_to_the_Network
.
1 .. Unpack.the.Tap.and.verify.that.you.have.all.components ..This.Tap.ships.
with.two.power.supplies.and.two.power.cords .
2 .. Connect.Network.Port.A.to.the.appropriate.network.device.using.an.RJ45.
CAT5e.straight-through.cable ..
3 ...Connect.Network.Port.B.to.the.appropriate.network.using.an.RJ45.CAT5e.
straight-through.cable ..
4 .. Verify.that.the.Tap.Network.Ports.are.cabled.in-line.between.two.devices .
®
www.netoptics.com
1
2
Port Aggregator
1
Network
Monitor
2
A
B
10
100
1000
LINK
ACT
In-Line
To network switch or router
To network switch or router