Net Optics GigaBit Fiber Media Converter - Manual (Page 9)

GigaBit Fiber Media Converter
Connecting the GigaBit Media Converter to the Network
. Connecting the GigaBit Copper Port to the Network
1 .. Using.a.CAT5e.cable,.connect.the.appropriate.switch,.server.to.the.GigaBit.
Media.Converter's.copper.port .
2 .. Supply.power.to.the.GigaBit.Media.Converter.using.the.two.power.sup-
plies.included.with.the.unit .
3 .. Compare.the.LEDs.on.the.Media.Converter.to.the.information.below.to.
verify.correct.setup .
PWR: Power ..Main/Redundant.power.LED.illuminates.green.when.device.
is powered on (Located on rear of unit).
F/O Link: Illuminates green when a good fiber optic link is established
UTP Link:.Illuminates.green.when.a.good.UTP.link.is.established .
F/O ACT: Illuminates green when activity on the fiber optic link is estab-
lished .
UTP ACT:.Illuminates.green.when.activity.on.the.UTP.link.is.established ..
FPN: Illuminates green when fiber auto-negotiation switch is set to an on
position ..
FD: Illuminates green when full duplex traffic is present.
Note: _______________________________________________________________
The CV-SX/GCU converter detects the incoming signal and
automatically makes the correct MDI (straight) or MDI-X (crossover)
configuration selection. Cable/connector conflicts can be ignored.
When lit, the 100 TX LED only shows that a 100BaseT source
has been connected to the GigaBit UTP port. Although showing a link,
the connection will be non-functional. A 100BaseT (100Mbs) data stream
is too slow for the GigaBit fiber-optic driver circuit to process. Net Optics
GigaBit Media Converters only operate successfully at GigaBit data rates.
______________________________________________________________________
•
•
•
•
•
•
•