Net Optics Flex Tap - Manual (Page 10)

6
Flex Tap Installation Guide
Specifications
Extract Cables or Flex Tap
If you want to extract a fiber optic cable from the Flex Tap, gently pull on the Flex Tap tab to slide out the
Flex Tap from the panel. Then remove the fiber optic cables by pinching the release tab (on LC connectors)
or pulling on the release sleeve (on MTP connectors).
Labels
The label displays the following information pertaining to the particular unit:
Description: Model description
Split Ratio
P/N:
Part number (model number)
Rev: Revision level
S/N: Serial number
Max Insertion Loss in dB: Light insertion loss measured at each port
Compliance Notifications for the LC and MTP models Taps
Specifications
Operating
Operating Temperature: 0º to 40º C
Storage Temperature: –10º to 70º C
Relative Humidity: 10% minimum, 95% maximum, non-condensing
Mechanical
Tap Dimensions: 1.63 inches High x 7.82 inches Deep x 0.66 inches Wide
Rack Dimensions: 1.74 inches High x 8.41 inches Deep x 19.0 inches Wide
Fiber Type
Multimode:
Core Size: 50/125µm; Wavelength: 850nm/1300nm
Core Size: 62.5/125µm; Wavelength: 850nm/1300nm
Single Mode:
Core Size: 8.5/125µm; Wavelength: 1310nm/1550nm
Connectors
Network Ports: (2) Duplex LC connectors or MTP connectors
Monitoring Port: (1) Duplex LC connector or MTP connector