Net Optics Fiber Taps - Manual (Page 9)

Fiber Tap
5
Connecting to the Network
1 . Connect Network Port A to the appropriate network device using a Duplex
LC cable .
2 . Connect Network Port B to the appropriate network device using a Duplex
LC cable .
3 . Verify that the Tap Network Ports are cabled in-line between two devices .
Note: ________________________________________________________________
The use of Singlemode (8.5μm), Multimode (50μm or 62.5μm), or LC cabling
is determined by the model purchased.
______________________________________________________________________
Figure 3: Connecting to the Network
To Network Device To Network Device
A B A A B B
OUT OUT OUT OUT IN IN
LASER
CAUTION!
Splitter Tap Splitter Tap
www.netoptics.com