Theatre Solution Lyric Auditorium Seating - Manual (Page 24)

Lyric Auditorium Seating Specifications 23
Lyric Specifications – Theatre Seating
(This section pertains to all models of the Lyric chair.)
PART 3 – OPTIONS
3.1 VENEER END PANEL
A. Provide manufacturer’s standard end panel at the end of the row. The configuration of the panel shall
follow the angle of the frame and back at the rear, and shall be vertical at the front edge. The panel shall
be constructed of 3/4” thick plywood with veneer on both sides and 1/8” thick solid wood on the vertical
edges. The end panel shall be stained to match the outer wood seat, back, and armrests.
3.2 POWDER-COATED END PANEL
A. Provide manufacturer’s standard end panel at the end of the row. The configuration of the panel shall
follow the angle of the frame and back at the rear, and shall be vertical at the front edge. The panel shall
be constructed of 3/4” thick medium density fiberboard with a durable powder-coated black finish.
3.3 AISLE LIGHT
A. Aisle lights shall be provided in accordance to the locations shown on the architectural drawings. The
units shall be of low voltage (24v) type and the light tube shall fit into a recessed area on the underside of
the armrest. The chair frame shall be prepared to accept the power wire. The necessary access holes
and blank cover plates shall be provided. The chair manufacturer shall also provide the necessary
transformers. All wiring and electrical connections shall be conducted at the job site and shall be the
responsibility of others.
3.4 SEAT IDENTIFICATION TAGS
A. Provide manufacturer’s standard shape polycarbonate number plates. Font shall be Times Roman. The
number plates shall fit into a recessed area at the top edge of the seat and shall be adhered with high-
strength pressure-sensitive tape.
3.5 ROW IDENTIFICATION AND DONOR TAGS
A. Provide manufacturer’s standard shape polycarbonate letter plates. Font shall be Times Roman.
3.6 REMOVABLE CHAIR
A. Provide the manufacturer’s standard one, two or three chair Removable units which shall include an
integrated steel sled-base that is engineered to conform to the row radii and includes two through holes
per chair for floor mounting.
3.7 FREESTANDING REMOVABLE CHAIR
A. Provide manufacturer’s standard freestanding removable chair which shall include an integrated steel
sled-base that is engineered to conform to the row radii and includes extended length floor plates to allow
the chairs to remain stable with no physical attachment to the floor.
3.8 BOOKRACK
A. The bookrack shall be constructed of hardwoods and hardwood plywood. Bookrack shall be assembled
with tongue and groove construction and finished with a catalyzed lacquer. The bookrack shall be
attached to the outer surface of the chair back. An optional attachment configuration shall consist of a
steel weldment attached to the chair leg. This configuration allows the bookrack to be located between
chair backs.
3.9 FLAT WOOD ARMREST
A. Shall be kiln-dried solid hardwood, nominally 1” thick x 2-1/2” wide x 12” long, stained to match the outer
back panel. The armrest will be fastened to the steel frame arm support with one 10-24 x 7/8” flat head
machine screw and one 10-24 x 2-1/4” flat head machine screw into threaded inserts on the underside of
the armrest.
3.10 CURVED WOOD ARMREST
A. Shall be kiln-dried solid hardwood, nominally 1 1/8” thick x 2 1/4” wide x 12 3/4“ long, stained to match the
outer back panel. The armrest will be fastened to the steel frame arm support with three #8 x 5/8” pan
head sheet metal screws.