Theatre Solution Lyric Auditorium Seating - Manual (Page 20)

Lyric Auditorium Seating Specifications 19
Lyric D1 Specifications – Theatre Seating
(This section pertains to the Lyric D1 model. The seat assembly has an inner-upholstered cushion and outer
injection-molded cover. The back assembly has an inner-upholstered cushion and outer plywood panel with stained
edges.)
PART 2 – PRODUCTS
2.1 SEATING
A. Provide from Theatre Solutions, Inc., 121 Park Avenue, Quakertown, PA 18951, the Lyric “D1” model as
follows:
1. Basic floor mounted chair
2. Inner upholstered seat and back
3. Outer wood veneer back with stained edges
4. Outer injection-molded plastic seat cover
5. Blow-molded plastic armrests
6. Aisle lights where indicated on the drawings
7. End panels where indicated on the drawings
B. Model noted is based on the Theatre Solutions, Inc. Lyric “D1” model with the intent of establishing the high
level of quality required for the project. Other brands submitted for approval will be given consideration
provided that a full seating mock-up, along with a complete list of specification discrepancies between the
proposed substitution and the product specified is received at least 10 working days prior to the bid date.
1. By offering a quote for this project, the bidder assumes full responsibility for complying with the
specifications for this project and shall be totally responsible for any expenses incurred if the
product quoted does not comply with the specifications.
C. Failure to comply with the warranty described in Part 4 of these specifications will be cause for
disqualification.
2.2 MATERIALS
A. Padding material shall be high resiliency polyurethane foam which conforms to the standards of the
California Bureau of Home Furnishings 117-75. The back shall be 1 1/4” thick. The seat shall be 1 3/4”
thick.
B. Seating fabric shall be _______________________________________________ with the color to be
selected from the standard choice of colors. All upholstery shall be first quality without creases, stretch
lines, or wrinkles.
C. Exposed wood on the outer back panel shall be veneer. The panel edges shall be stained to match the
veneer faces. All wood shall be stained in any of the manufacturer’s standard finishes. The outer plastic
cover shall be impact resistant polypropylene. The arms shall be high density polyethylene.
2.3 FABRICATION, GENERAL
A. Fabricate the theater seating in contoured form for maximum comfort using materials that are carefully
selected to be free from defects, objectionable projections, or irregularities. Insure smooth round corners
and edges to present the least possible snagging and pinching hazards.
2.4 MOUNTING
A. Fabricate seating units for floor attachment, using standards that have been manufactured to conform to
the slope of the floor while maintaining seat and back in same angular relationship to standards throughout.
2.5 METAL STANDARDS
A. Frame shall be 3/4” x 2” x 16 gauge cold-rolled welded steel tubing; 1/4” x 3 1/2” hot-rolled steel plate, 1/4”
x 2 1/8” hot-rolled steel plate and 11 gauge formed steel brackets welded into one integral freestanding
structure upon which the seat, back, and arms are assembled. Pivot and stop pins shall be machined from
cold-finished steel to tolerances of +0.000 -0.005. Floor mount plate shall be .100” thick hot-rolled pickled-
in-oil steel formed and embossed for 1/4” mounting anchors. A molded plastic cap shall be fitted into the
embossed mounting area to conceal the anchoring hardware. Exposed floor anchoring hardware will not
be acceptable.
2.6 UPHOLSTERED CHAIRS