Billet Specialties Premium Tru Trac Serpentine System - Big Block Chevy - Manual (Page 6)

www.billetspecialties.com www.billetspecialties.com
11
Figure 6: Install the Tensioner
A] Apply anti-seize to the 8mm-1.25 x 25mm socket set stud and thread
into the remaining long spacer nut with boss, tighten with 4mm Allen key
(stud installs in spacer nut opposite of boss).
B] Attach the long spacer nut with boss to the backside of tensioner.
C] Attach assembly to lower compressor bracket ear by applying
anti-seize to the 3/8-16 x 1” Hex Head Flange Bolt and threading it
through the lower ear of the compressor bracket into the spacer
nut boss.
Do not completely tighten at this time.
A
B
C
Tensioner Spacer Nut x1
8mm-1.25 x 25mm
Socket Set Cup Point
Figure 5: Install Power Steering Bracket
Without Power Steering: Apply anti-seize to the two 7/16-14 x 1-1/2”
socket head cap screws and install them through the lower end of the
alternator bracket into the block.
With Power Steering: Apply anti-seize to the threads of the two
7/16-14 x 2-1/4” socket head cap screws.
A] Place power steering bracket onto the lower end of the
alternator bracket.
B] Thread the two screws though both brackets and into the
block and tighten firmly.
B
A