Billet Specialties Premium Tru Trac Serpentine System - Big Block Chevy - Manual (Page 2)

Short Spacer Nut
2-3/8” x1 x2
Long Spacer Nut
3” x3
Zinc Coated
Hex Nuts
(Discard After Use)
x1
Tensioner Spacer Nut With Boss
x2
5/16-24 x 3” Socket Head Cap Screw
Power Steering Pump
x2
5/16” Lock Washer
3/8-16 x 3” Threaded Stud x4
x2
7/16-14 x 2-1/4” Socket Head Cap Screw
Power Steering Bracket
Required Tools & Materials
Anti-seize Compound
Loc-Tite® Thread Locker
RTV Silicone
Gasket Scraper
Scotch-Brite® Pad
3/8-16 Thread Chaser* & Holder
7/16-14 Thread Chaser*
*Thread chasers are available at your
local parts store and are different from
a thread cutting tap.
3/16” Allen
5/16” Allen
1/4” Allen
3/8” Allen
4mm Allen
5mm Allen
6mm Allen
PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLING ANY COMPONENTS
OF THE TRU TRAC SERPENTINE SYSTEM
9/16” Combo Wrench
11/16” Combo Wrench
3/4” Combo Wrench
Socket Wrench & Extension
10mm 12pt. socket
12mm 12pt. socket
3/8” 12pt. socket
TECH TIP:
Billet Specialties recommends the use of Anti-Seize on all
fasteners to prevent thread lock-up.
Tech Line: 708.588.0505
Fax: 708.588.7181
www.billetspecialties.com
Skin Board #1 - Packaged with Power Steering Pump Skin Board #2 - Packaged with Water Pump
3/8”-16 x 1” Hex Flange Bolt
x1
Prepping The Block
- Disconnect the battery.
- Remove the existing alternator, air conditioning compressor and
associated brackets
- Remove pulleys and water pump
-Remove all traces of gasket and sealer with a gasket scraper and
Scotch Brite® pad.
- Clean threads in block by chasing the water pump mounting
threads with a 3/8-16 thread chaser and the threads on the two lower
bosses on either side of the balancer with a 7/16-14 thread chaser.