Billet Specialties Premium Tru Trac Serpentine System - Small Block Chevy - Manual (Page 7)

www.billetspecialties.com • Tech Line 708.588.0505 12 Small Block Chevrolet Tru Trac - 13225 / 13125 13
Figure 9: Install Bridge Bracket
Apply anti-seize to:
• Three (3) 8mm-1.25 x 25mm 12-point cap screws
• One (1) 8mm-1.25 x 25mm flat head cap screw
A] Align and install the bridge bracket using the three 8mm-1.25 x 25mm 12-point cap screws,
threading into the stainless stand-offs. Install the 8mm-1.25 x 25mm flat head cap screw
through the bridge bracket and into the boss on the tensioner housing. Finger tighten.
Figure 11: Install Alternator
Apply anti-seize to:
• One (1) 8mm-1.25 x 25mm 12-point cap screw
• One (1) 10mm-1.50 x 80mm 12-point cap screw
Align the alternator with the two mounting locations on the bridge bracket.
A] Install the 10mm-1.50 x 80mm 12-point cap screw through the lower mounting location on
the alternator and finger tighten. Install the 8mm-1.25 x 25mm 12-point cap screw through
the alternator and into the bridge bracket.
At this time tighten both fasteners firmly.
Note: Due to the polishing process the width of the mounting bosses may vary, 10mm shim
washers are provided if needed for the lower mounting location.
Figure 10: Tighten All Stand-offs & Bridge Bracket Hardware
• Firmly tighten the four (4) stainless stand-offs previously installed.
• After the stand-offs have been tightened, now tighten the 12-point caps screws and flat
head cap screw that attach the bridge bracket.
• Re-check remaining hardware, all hardware should be tightened firmly at this time.
A A