Billet Specialties Premium Tru Trac Serpentine System - Small Block Chevy - Manual (Page 5)

www.billetspecialties.com • Tech Line 708.588.0505 8 Small Block Chevrolet Tru Trac - 13225 / 13125 9
Figure 3: Install Power Steering Bracket
Kits Without Power Steering:
For kits without power steering apply anti-seize to the two (2) 3/8-16 x 1-1/4" socket head cap
screws and install through lower end of the alternator bracket and into the block. Tighten
firmly.
Kits With Power Steering:
A] For kits with power steering apply anti-seize to the two (2) 3/8-16 x 2" socket head cap
screws and install by threading through the power steering bracket as shown above, through
the alternator bracket and into the block. Tighten firmly.
Figure 5: Install Water Pump
A] Install the included water pump by sliding the unit over the exposed ends of the block
mounting studs previously installed.
Figure 6: Install Stainless Stand-offs
A] Apply anti-seize to the exposed threads
of the block mounting studs and attach the
stainless standoffs as shown with hex end
out. Only hand tighten at this time.
B] Make sure to install the shorter (1-3/4")
stainless stand-off on the lower passenger
side block mounting stud as shown. Hand
tighten at this time. Figure 4: Install Lower Tensioner
Bracket
Apply anti-seize to two (2) 3/8-16 x 2"
socket head cap screws.
A] Locate and install the lower
tensioner bracket by threading the
two 3/8-16 x 2" socket head screws
through the bracket and into the lower
mounting bosses on the passenger
side of the block. Tighten firmly.
A A
A
B
A