3 ‘help’ command – SENA NEMO10-SK User Manual
Page 23

23
--- Host ---
Host_mode: tcps
Local_port: 6001
Inactivity_timeout(sec): 300
--- Serial ---
Baudrate: 9600
Data_bits: 8_bits
Parity: None
Stop_bits: 1_bit
Flow_control: None
DTR_option: Always_high
DSR_option: None
Interchar_timeout(ms): 50
>
Figure 2-17 Getting all parameters screen
2.4.3 ‘help’ Command
With ‘help’ command, users can find command usage help in the console screen. Basic command
usage is as follows:
help [group] +
where,
if group is omitted, overall help screen will be displayed
if group is specified, ‘set’ command usage of specified group will be displayed.
Figure 2-18 shows help screen when no group is specified while Figure 2-19 shows help screen with
‘ip’ group specified.
> help
set group par1 [par2 ...] +
- group = 'ip','host','serial' or 'admin'
- par1 ... = configuration parameters. Use * to keep a parameter's value
get [group] +
- group = 'ip','host','serial','admin' or 'status'
- If group is specified, shows settings of the group.
- If group is omitted, shows settings of all groups.
help [group] +
- If group is omitted, shows this screen.
- If group is specified, shows 'set' command usage of the group.
factorydefault [option] +
- if option is omitted, all parameters are set with factory default values.
- if option='-ip',
all parameters except IP settings are set with factory default values.
save +
- Save changes
exit +
- Exit without rebooting the device
reboot +
- Exit and reboot the device
Figure 2-18 Help screen