SENA NEMO10-SK - Manual (Page 17)

17
2.3. Accessing Console Port
There are two ways to access console port of the NEMO10 depending on whether the user is located
at a local site or a remote site.
- Serial console:
Local users can connect directly to the serial console port of the NEMO10 using serial
console/data cable (null-modem cable). The serial port of the NEMO10 is used as the console
port as well as the data port. To use the serial port as the console port, slide Data/Console
switch on the test bed to the Console side.
- Remote console:
Remote users can make a telnet connection to the remote console port (port 23) of the NEMO10
via TCP/IP network.
Both methods require the user to log into the NEMO10 in order to continue.
2.3.1 Using Serial Console
1) Connect the one end of the serial console cable to the DB9 serial port of the NEMO10 test
bed.
Figure 2-8 Connecting a serial console cable to the NEMO10 test bed
2) Connect the other end of the cable to the serial port of user’s computer.
3) Slide Data/Console switch (SW2) on the NEMO10 test bed to Console side.
SW2
Figure 2-9 Data/Console switch of the NEMO10