SENA Parani-BCD110 - Manual (Page 51)

51
Purpose Change device name
Parameters $string= New device name (Default=”BCDx10_v2.0.6-445566”)
Description Parani-BCDx10 can have a user friendly name for easy identification. The name allows up
to 30 alpha-numeric characters.
Example AT+BTNAME=”My-Parani-BCD ”
B.3.31. AT+BTLPM,n

Response  OK
Purpose Set low power mode
Parameters n=0: Inactivate (Default)
n=1: Activate
Description During no data transmission, Parani-BCDx10 can be in low power mode to save the power.
Low Power Timeout is set to S-register S52.
So if low power mode is activated and if there is no data transfer during a period specified
in S52, Parani-BCDx10 will be entered low power mode.
Please note that it takes a few seconds to make the Parani-BCDx10 out of low power
mode.
B.3.32. AT&V

Response  S0:m0;S1:m1; …Sn:mn
 OK
Purpose Display all the S-registers
Description All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
B.3.33. AT+PASS=$string

Response Remote Configuration Enabled 
Purpose Input password in remote configuration mode.
Parameters $string= Password (Default=”0000”)
Description Input password for authentication in remote configuration mode.
Example AT+PASS=1234
B.3.34. AT+CHPASS=$string

Response  OK
Purpose Change password used in remote configuration mode.
Parameters $string= New password
Description Change password used in remote configuration mode. Password length is up to 8.
Example AT+CHPASS=12345678
B.3.35. ATSnn?
