SENA Parani-BCD110 - Manual (Page 44)

44
B.3. Command Description
B.3.1. ATZ

Response  OK
Purpose Software Reset
Description This has the same effects as Powercycling the unit.
This command disconnects any connected Bluetooth device, and stops ongoing tasks.
After rebooting, the status will be decided by the preset operation mode.
Some AT commands require the ATZ command be run so that the commands can take
effect.
B.3.2. AT&F

Response  OK
Purpose Hardware reset
Description This has the same effect as initialization by pressing the factory reset button.
All parameters are initialized to factory defaults
B.3.3. AT

Response  OK
Purpose Check the connection status with host equipment
Description Check if the connection to host equipment is operating normally. The serial parameters of
Parani-BCDx10 must be same as those of host equipment. If not, the Parani-BCDx10 will
not respond or ‘ERROR’ message will appear or an abnormal sequence of strings will
appear.
B.3.4. AT+UARTCONFIG,Baudrate,Parity,Stopbit,Hwfc

Response  OK
Purpose Set Serial parameters
Parameters Baudrate=1200/2400/4800/9600/14400/19200/38400/57600/115200/230400/460800/921600
(Default=9600)
Parity=N/E/O (Default=N)
Stopbit=1/2 (Default=1)
Hwfc(Hardware Flow Control)=0/1 (Default=1)
Description The Serial parameters can be set or changed. The factory default is 9600, N, 1, 1.
To take effect the ATZ command must be used or Powercycle the unit.
Example AT+UARTCONFIG,115200,N,1,1
B.3.5. AT+BTINFO?

Response  112233445566,DeviceName,Mode,Status,Auth,Encryp,FlowControl
 OK
Purpose Display Bluetooth settings
Description The current Bluetooth settings are displayed including BD address, Device name,