A 4.4. hardware test menu – SENA PS810 User Manual
Page 99
99
----->1
Enter Current Data(mm/dd/yy) : 05/20/05
Press the ENTER key to continue!!
-----------------------------------------------------------------------------
RTC Configuration
-----------------------------------------------------------------------------
Select Menu
1. Data(mm/dd/yy) : 05/20/05
2. Time(hh:mm:ss) : 15:02:41
----->2
Enter Current Data(hh:mm:ss) : 15:03:40
Press the ENTER key to continue!!
-----------------------------------------------------------------------------
RTC Configuration
-----------------------------------------------------------------------------
Select Menu
1. Data(mm/dd/yy) : 05/20/05
2. Time(hh:mm:ss) : 15:03:41
----->
Figure A-10 RTC configuration within Bios Menu Program
A 4.4. Hardware Test Menu
Using the Hardware test menu, the user can test hardware components. There are three hardware
test modes:
-
One time
-
Looping (without External test in Auto test)
-
Looping (with External test in Auto test)
If the user selects One time, an auto test or each component test is performed just once. In this mode,
the ping test to the remote host (server IP address) and UART test are also performed once.
If the user selects Looping (without External test in Auto test), the auto test is performed repeatedly
until the user presses the
address) and UART test are not performed.
Note: To perform the test on the Ethernet and UART properly, the user must connect an Ethernet
cable to the Ethernet port of the Pro Series and must plug the loopback connector to all the serial ports
of the Pro Series. There must exist a remote host with a valid IP address. The default server IP
address is 192.168.0.128 and it can be changed using the [Firmware Upgrade] menu. Otherwise, the
test may not be performed properly.
-----------------------------------------------------------------------------
Hardware Test
-----------------------------------------------------------------------------
Select menu
0. Test Mode - One Time