SENA PS810 - Manual (Page 53)

53
ATIn [CR][LF]
I, I0 : display “Sena Technologies, Inc.”
I3 : display model number
Others : display “OK”
<=
AT\Tn [CR][LF]
Set inactivity timer to n minutes
\T, \T0: inactivity timer disabled (default)
ERROR [CR][LF]
or
OK [CR][LF]
ATBn, ATCn, ATLn, ATMn,
ATNn, ATP, ATT, ATYn,
AT%Cn, AT%En, AT&Bn,
AT&Gn, AT&In, AT&Qn,
AT&V, ATMn, AT\An,
AT\Bn, AT\Nn, ATXn
None OK [CR][LF]
ATS?, ATSn=x
Internal S-register can be set or read.
Default values are shown on Table 4-4
Changed values are not preserved if the power is off.
<=
AT&Cn, AT&Wn, AT&Zn=x
Factory default response is ERROR.
This can be changed to OK by user configuration.
(Figure 4-8) ERROR [CR][LF]
or
OK [CR][LF]
ATFn [CR][LF] None
If n=1 OK [CR][LF]
Else ERROR [CR][LF]
ATWn None
If n=0 OK [CR][LF]
Else ERROR [CR][LF]
AT+DATE
Set the system data and time
e.g.
AT+DATE=2007.01.01-14:30:30
AT+NET
Set (or Display) the IP address and the subnet mask.
e.g. AT+NET= 192.168.17.9/255.255.0.0
AT+GATEWAY
(AT+GW) Set(or Display) the default gateway
e.g. AT+GATEWAY=192.168.1.1
AT+DNS
Set(or Display) the domain name server.
e.g. AT+DNS=168.126.63.1/168.126.63.2
AT+NETINFO *
(AT+NI)
Display IP configurations (IP address, subnet mask, mode,
gateway, dns)
e.g. AT+NETINFO
=> ip mode : dhcp
ip address : 192.168.231.10
subnetmask : 255.255.0.0
gateway : 192.168.1.1
primary dns : 168.126.63.1
If success,
OK [CR][LF]
If failure,
ERROR [CR][LF]
* Not supported in PS810
Table 4-3 AT commands Response Code
Verbose Code
(After “ATV1” command executed) Non-Verbose Code(Numeric Code)
(After “ATV0” command executed) Description
OK 0 Command executed
CONNECT 1 Modem connected to line
RING 2 A ring signal has been detected
NO CARRIER 3 Modem lost carrier signal
ERROR 4 Invalid command