Ocean Optics LLS Series LED - Manual (Page 7)

LLS Series Installation and Operation Instructions
300-00000-011-01-201301 7
The fiber-coupled LED module has an SMA connection so that it can be screwed into the SMA
connector on the front of the LED light source.
Fiber-coupled LED Module Installed Fiber-coupled LED Module
Removing the LED Module
The LEDs all use the same style of module to plug into the LLS board. This can be accessed at the
bottom of the LLS box. The LED module board can be unplugged by simply pulling it out of its
“blind mate” socket. Gently rocking the connector from side to side helps to loosen it.
Removing the LED Connection Board LED daughter
External Power Requirements
Wavelengths 250nm - 355nm 6W 15V 0.4Amp
Wavelengths 365nm and above 18W 6V 3Amp