Ocean Optics LLS Series LED - Manual (Page 5)

LLS Series Installation and Operation Instructions
300-00000-011-01-201301 5
Pin # Description
12 N/A
13 N/A
14 N/A
15 Analog Control Input (requires a jumper change to use.) Never exceed 2.5Volts into
this pin.
External Triggering and Control
There are two sets of internal jumpers located on the main PCB board. These are accessible by
removing the four screws located on the top of the light source.
• J5 controls the modulation mode and switches the control from single trigger to direct
modulation.
• J6 selects the source of the analog control voltage.