Ocean Optics JAZ-CBL-DB15 Accessory Cable - Manual (Page 2)

JAZ-ADP-GPIO and JAZ-CBL-DB15 Instructions
2 013-40000-000-01-201102
2. Locate the DPU module in your Jaz stack.
3. Remove the screws currently attached to the DPU front panel
4. Use the new screws provided to attach the adapter to the DPU module as shown below:
5. Follow the instructions in Connecting the Accessory Cable to attach the accessory cable as
shown below:
Cable Pinouts
Pin # Function Description
1 GND Ground
2 RX RS-232 Data In
3 TX RS-232 Data Out
4 GND Ground
5 EXT_TRIG_IN 3.3v Logic
6 LAMP_ENABLE GP_OUT
7 SCL1 OOI use only. See the Jaz Data Sheet for more
information.
8 CONT_STROBE (3.3v Logic)