Ocean Optics JAZ-CBL-DB15 Accessory Cable - Manual

013-40000-000-01-201102
JAZ-ADP-GPIO Adapter and
JAZ-CBL-DB15 Accessory
Cable Instructions
JAZ-ADP-GPIO Adapter
This accessory converts the 20-pin GPIO connector on Jaz DPUs manufactured on January 1, 2008 to
the mini-HDMI connector used by the Jaz DPU GPIO (Jaz DPUs manufactured after January 1, 2008).
The mini-HDMI connector provides additional functionality such as triggering.
Note
In addition to the mini-HDMI connector provided on the JAZ-ADP-GPIO Adapter,
additional firmware is necessary to use some of the new functions. Upgrading this
firmware may require an RMA to return the unit to the factory as shown below:
Module Firmware Version Field Upgradeable?
DPU Blackfin DPU-GPIO uImage 22-SEP-09 or newer Yes
DPU FPGA 0x0085 or newer No
Spectrometer FPGA 0x0093 or newer No
Attaching the JAZ-ADP-GPIO Adapter
► Procedure
1. Unpack the connector. Your package should contain the following:
 One JAZ-ADP-GPIO
 Four 2-56 x 3/16” Phillips head screws to attach the adapter to the DPU module in your
Jaz stack. (Only two screws are needed; two extra screws are provided.)