Ocean Optics RaySphere 1700 QuickStart - Manual (Page 7)

RaySphere and RaySphere 1700 Instructions
RAYSPHERE-1700-01-201304 7
Validating the Test Results
Check the following to be sure that you are collecting valid data:
 The RaySphere was allowed to warm up for at least 20 minutes before starting the test.
 No error or warning messages were received when the calibration file was loaded.
 The spectra recording was during the stable flash time phase. Check that all marks for
Start and End of Recording in the Photocurrent graph are at a stable flash time.
Specifications
Specification Value
Electrical:
Input voltages 90 – 164 VAC
Input frequency 47 – 63 Hz
Power 75 W
Overvoltage protection 110 – 130% of main output
Fuse M1.6 A
Trigger connection BNC connector
Connector: SMA 905
Optical:
Optical input power 150 W to 2000 W
Wavelength range*:
RaySphere
RaySphere 1700
350 – 1100 nm
300 nm – 1700 nm
Optical Trigger:
Trigger delay 0 – 160 ms
Time resolution 0.87 µs
Jitter 150 ns
Internal time resolution 2.54 µs
Electrical Trigger:
Electrical trigger type High level
High level 5 V or 24 V (selected at the power supply. Galvanically isolated input.)
Minimum high time 100 ns
Connector BNC