Ocean Optics Laser-785 - Manual (Page 13)

2: Set-up and Operation
Operation
Read the following warnings before attempting to use the laser:
WARNINGS
DO NOT LOOK DIRECTLY INTO THE LASER. LASER RADIATION IS
HAZARDOUS TO THE EYES. When the laser is in operation but the beam is not
in use, block radiation by closing the shutter output aperture. AVOID DIRECT
EXPOSURE TO THE BEAM.
Never try to connect or disconnect the output fiber to or from the SMA connector
during laser operation. This could destroy the internal fiber optics.
► Procedure
1. Turn the power on by rotating the key until it is horizontal (lined up with the dark circle on the
left). The green Power LED lights.
2. Push the Emission button on the front panel to turn on the laser. The yellow Emission LED
lights.
3. Push the Emission button again to turn off the laser. The Emission LED turns off. Then turn off
the power with the key (key should rest in a vertical position).
IN CASE OF EMERGENCY
To shut down the laser for an emergency, press the large, red emergency button
(labeled PUSH) on the front panel. To release the switch, turn the knob clockwise.
4. When the laser is not in use, remove the fiber from the OUTPUT connector and replace the safety
cap.
000-10000-080-02-0505 5