Ocean Optics Laser-785 - Manual (Page 12)

2: Set-up and Operation
Rear Panel View
Set-up
► Procedure
1. Carefully clean the tip of the output fiber.
2. Unscrew the safety cap from laser’s SMA receptacle (OUTPUT).
3. Connect the fiber to the laser’s SMA receptacle (OUTPUT).
4. Connect the power cord to the receptacle on the rear panel of the laser and the other end to a
100-240 VAC power wall outlet. The power cord is a 3-wire cable; ensure that a suitable ground
wall outlet is used.
5. Ensure that the remote control connector on the laser’s rear panel is plugged in and the remote
control circuit has been completed. The laser will be disabled if the center two pins are
disconnected.
4 000-30000-010-02-0605