Ocean Optics HPX-2000 - Manual (Page 22)

A: Bulb Replacement
14 000-10000-080-02-201207
5. Remove the cap (Figure 2, #3) and the beam cover (Figure 2, #4) from the HPX-2000.
6. Remove the four recessed screws (Figure 2, #1), both front and back on both sides of the
HPX-2000.
7. Remove the cover housing of the HPX-2000.
Figure 1 Figure 2
8. Loosen the screws (Figure 3, #5) by hand, disconnect the plug (Figure 3, #6), and remove the old
bulb from the HPX-2000.
9. Place the new HPX-2000-BM bulb inside the housing, connect the plug, and replace the screws.
10. Close the housing and screw the 4 screws (Figure 2, #1) into the sides of the housing.
11. Replace the cap (Figure 2, # 3) and the beam-cover (Figure 2, #4).
Figure 3
1
2
4
3
6
5