Factory Direct Hardware Brizo 63052LF Belo - Manual (Page 8)

A. B.
A.
Ensure all fittings and end connections
are free of debris. Faucet fittings (1)
are 3/8" compression, with ends
colored red for hot and blue for cold.
Loop tubing (2) if it is too long. Note:
Recommended tubing minimum
bend diameter is 8". Secure metal
nut (3) on faucet tube to supply valve
connection (4) and hand tighten, then
tighten one additional turn with wrench.
DO NOT OVERTIGHTEN. Repeat
for other tube. WARNING: Do not
use pipe dope or other sealants on
water line connections.
B.
Place bucket under faucet quick
connect fitting (1), open both supply
valves (2) and turn faucet valve on by
operating handle (3) for one minute.
Important: This flushes away any
debris that could cause damage
to internal components. When
complete, close both supply valves
and turn faucet valve off to shut off
water flow.
8
Water Line Connections
1
3
4
2
2
1
4A
3
2
2