Factory Direct Hardware Brizo 63052LF Belo - Manual (Page 12)

12
6
Faucet Inspection and Operation
3
2
1
1
A.
Unlock
Lock
A.
Turn on hot and cold water supplies
(1). Pull the hose assembly (2) out of
the spout. Be sure to hold the end of
the sprayer down into the sink and turn
faucet handle (3) to the mixed position
for one minute. Check all connections at
arrows for leaks. Re-tighten if necessary,
but do not overtighten.
B.
Sprayer will lock into position when
brought into proximity of the spout
magnet. The sprayer can be removed by
either pulling directly out from the spout
or by twisting 90° in either direction
which will cause the magnets to repel
and the head to decouple from the
spout (recommended). Check the
operation of the sprayer by operating the
trigger (4) from aerator to spray. The
diverter will remain in the last diverted
mode. To reduce or pause flow, push
selector button further into wand. The
bar/prep faucet is a two function sprayer
only. Press button (5) to choose
between modes.
4
5
B.
OR