Dexter Laundry T-50X2 EXPRESS (On-Premise) - Manual (Page 8)

Temporary Dryer Controller Programming Example
Requirements: Dry a load with 40 minutes of actual heat at 18SoF and fi ve minutes of cool down.
The following procedure will show you how to temporarily modifY the existing dry cycle 1 program for
one cycle of drying. It is based on the assumption that the factory defaults have not been permanently
changed. If they have been changed, the steps of this procedure will be the same, but the values that
are displayed will be different. The amount of times that the dryer controller touch pad UP or DOWN keys
must be pressed and released may also be different.
If you want the change to be permanent, go to the “Permanent Dryer Controller Programming” section of
this manual.
Procedure
1. After the load has been placed in the dryer, press and release the UP or DOWN touch pad key on the
dryer controller until the L.E.D. for dry cycle 1 is illuminated.
2. Press and release the CYCLE key on the dryer controller touch pad. You will see the number “35” on
the dryer controller display. The programming L.E.D. and dry time L.E.D. will be illuminated.
3. Press and release the UP arrow key on the dryer controller touch pad 10 times so the display will
show a fl ashing “45”. When the UP arrow touch pad key is pressed the fi rst time, the number “36” will
be fl ashing on the dryer controller display. Each number after that will also fl ash.
4. Now, press and release the SELECT/ENTER touch pad key on the dryer controller. The number “45”
will stop fl ashing and the dry time L.E.D. will switch off. The dryer controller display will now show
“180”, the temperature L.E.D. will illuminate, and the programming L.E.D. and dry cycle 1 L.E.D. will
remain on.
5. Press and release the UP arrow key on the dryer controller touch pad one time so the controller dis-
play will show a fl ashing” 185”. Each press of the UP arrow key will increment the temperature by fi ve
degrees.
6. Now, press and release the SELECT/ENTER touch pad key on the dryer controller. The number “185”
will stop fl ashing and the temperature L.E.D. will switch off. The dryer control display will now show
a number “5”, the cool down L.E.D. will illuminate, and the programming L.E.D. and dry cycle 1 L.E.D.
will remain on.
7. Press and release the SELECT/ENTER key on the dryer controller touch pad, since the desired cool
down time is fi ve minutes. After you press the SELECT/ENTER touch pad key on the controller, the
cool down L.E.D. and programming L.E.D. will switch off. The controller display will remain at “5” and
the cycle 1 L.E.D. will remain on.
You are now ready to start the new dry cycle. This new dry cycle will be in effect for one dry cycle only.
After the dry cycle is done, or if the STOP touch pad key on the dryer controller is pressed and released
twice, consecutively, the cycle 1 program will revert to the factory default settings.
If you press the START touch pad key on the dryer controller, the controller display will change from the
number “5” to the number “45” and dry cycle 1 will begin.
Permanent Dryer Controller Programming
The permanent programming mode will allow the change of the stored dry cycle settings in the dryer
controller until the operator physically changes them again. The factory default settings can be restored in
the dryer controller by pressing the default settings pushbutton on the back (component) side of the dryer
8
Part # 8533-069-001 12/13