Dexter Laundry T-50X2 EXPRESS (On-Premise) User Manual

Page 4

This touch pad switch will start the operation of a dry cycle if
pressed and released once. Pressing and holding this touch pad
switch will display the current temperature of the dryer heat sensor
as long as it is held in the depressed position.

Description

This message is displayed after a dry cycle is complete and the
dryer loading door has been opened or the STOP touch pad key on
the dryer controller has been pressed and released twice.

This message blinks immediately after completion of the dry cycle
and continues to blink until the stop key on the dryer controller
touch pad is pressed or the dryer loading door is opened.

This message is displayed when entering the permanent
programming mode.

This message appears while the dryer is in the heating time of a
dry cycle. The decimal point will blink if the output for the gas valve
is on, or remain on constantly if the output for the gas valve is
not on. The number represents the total time left in the dry cycle
(includes cool down time).

This message appears when the cool down time of the dry
cycle is reached. The letter “C” represents the cool down (non-
heating) part of the dry cycle. The number(s) after the letter “C”
represent(s) the total time remaining in the dry cycle.

This message appears if there is a dryer fault. The letter “F”
indicates a fault and the number after the “F” represents the
specifi c fault that has occurred. There are fi ve different faults that
can appear (Fl through F5).

Start

Message

LOAd

donE

Prog

.15

C02

Part # 8533-069-001 12/13