Dexter Laundry T-50X2 EXPRESS (On-Premise) - Manual (Page 6)

During the dry cycle, either pressing the STOP touch pad key on the dryer controller or opening the dryer
loading door, will stop the dry cycle and not clear it. If you press the STOP touch pad key on the controller
and then open the dryer loading door the dry cycle will not be cleared. However, if you open (or open and
close) the dryer loading door and then press the STOP touch pad key on the dryer controller, the present
dry cycle will be cleared and the word “LOAd” will appear on the dryer controller display.
There are two jumpers and one push button on the component side of the dryer controller printed circuit
board.
The jumper located at the back right side of the each circuit board controls whether the controller display
shows and operates in the Fahrenheit or Celsius mode. This jumper is labeled as TEMP SELECT and has
three pins. The back and middle pins are for Celsius and the front and middle pins are for Fahrenheit,
which is indicated by the letter C for Celsius and the letter F for Fahrenheit.
The other jumper, located at the back middle side of each circuit board controls, is used for choosing ei-
ther a reversing or non-reversing type of dryer. This jumper is labeled as REV and NON-REV. This jumper
must be in the non-reversing position, which are the front and middle pins. If the jumper is in the revers-
ing position, the heating part of the dry cycle will not operate properly. The dryer will not reverse direction
either.
The push button, which is located at the middle center of each circuit board controls, is used to reset all
fi ve of the dry cycles to the factory default settings. It is labeled as DEFAULT SETTINGS. Even the dry
cycles that have been modifi ed using the permanent programming procedure will be changed back to the
factory default settings when using this push button. This push button must be pressed and held for at
least three seconds with power applied to the dryer controller circuit board.
If changing a jumper, remove power before moving jumper and then move jumper. Before restoring
power, press and hold the DEFAULT SETTINGS pushbutton. Then, restore power and release the DEFAULT
SETTINGS pushbutton after three seconds of restoring power.
Temporary Dryer Controller Programming
The temporary programming mode will allow the change of the stored dry cycle settings in the dryer con-
troller for one complete dry cycle. After the dry cycle is complete, the default settings that existed before
the temporary change are restored. The temporary dry cycle can be stopped and cleared at any time dur-
ing the dry cycle operation.
To temporarily change a dryer controller cycle, follow the procedures below. Things that are displayed on
the 4-digit numeric display will be in “quotation marks”. Keys on the dryer controller touch pad that physi-
cally need to be pressed will be in CAPITAL AND BOLD LETTERS.
If, at any time, you want to escape the temporary programming mode while changing the program set-
tings, you can press the STOP key on the dryer controller touch pad if the 4-digit numeric display is not
fl ashing. The SELECT/ENTER key on the dryer controller touch pad can be pressed and released to enter
the fl ashing value shown on the 4-digit numeric display and allow you to escape.
If you press and release the STOP key on the dryer controller touch pad, when the 4-digit numeric display
is not fl ashing, the temporary changes to the dry cycle program will be cancelled. The stored dry cycle
settings that existed before the temporary change will then be restored.
If, at any time, you want to start the temporary dry cycle during the temporary programming mode, press
and release the START key on the dryer controller touch pad if the 4-digit numeric display is not fl ash-
ing. The SELECT/ENTER key on the dryer controller touch pad can be pressed and released to enter the
fl ashing value shown on the 4-digit numeric display and allow you to start the temporary dry cycle. If you
start the temporary dry cycle, the 4-digit numerical display will change to the total dry time and count
down to 0 as the dry cycle progresses.
6
Part # 8533-069-001 12/13