Dexter Laundry T-600 (30-Cycle) - Manual (Page 16)

16
entered.)
The Water Level LED lights and the Water Temperature LED are out. The
water level for this segment is displayed. If no change is required,
then continue to the next instruction. If a change is required, then use
the SCROLL UP/SCROLL DOWN buttons to change the water level. {"HI" is a
high water level and "LO" is a low water level} When the desired water
level is selected, continue to the next instruction.
When the No Water bath is selected, the water level has no effect.
Either water level can be selected.
9.
Push the green ENTER button. (The water level has now been entered.)
The Injection Source LED lights and the Water Level LED are out. The
injection source for this segment is displayed. If no change is
required, then continue to the next instruction. If a change is
required, then use the SCROLL UP/SCROLL DOWN buttons to change the
injection source. See the Injection Source table for proper selection.
If zero is selected, then no injection source is active for this segment.
When the desired injection source is selected, continue to the next
instruction.
When the No Water bath is selected, injection signals are prohibited by
the electronic controller. The programmed injection source value is
ignored.
10.
Push the green ENTER button. (The injection source has now been
entered.)
The Spin Time LED lights and the Injection Source LED are out. The spin
time for this segment is displayed. If no change is required, then
continue to the next instruction. If this value requires changing, then
use the SCROLL UP/SCROLL DOWN buttons to change the spin time in 1 min.
increments to the desired value, then continue to the next instruction.
Settings range is from 0 min. to 10 min. except for the Final
Rinse/Extract segment where the setting range is 1 min. to 10 min.
REMINDER: If the spin time is set to zero, there will be no spin at the
end of the bath.
11.
Push the green ENTER button. (The extract time has now been entered.)
Once depressed, the Spin Time LED is out and the editing of one segment
is complete. The next sequential cycle segment LED lights, unless the
segment edited above was the Final Rinse/Extract segment. If the Final
Rinse/Extract segment is edited, after step eleven, the cycle programming
is complete and the machine will return to the Programming Mode awaiting
a cycle select (Step 3).
To exit the programming mode, depress the red STOP button when one of
the nine cycle segment LED lights is lit. The programming changes made
prior to the program exit are retained and the cycle is updated.
PROGRAMMING INSTRUCTIONS - ENTERING NEW CYCLE
The T600 comes from the factory with 29 preset wash cycles programmed into the